We ship Australia Wide*. Shipping $25 flat fee. FREE shipping on orders over $500

Roller Blinds Installation Guide

Install Roller blinds quickly and easily with our simple step by step instructions

Parts included in the package:

  • Brackets (two types: one used for the chain control side of the blind, and one that supports the pin, the non-control side)
  • Blind
  • Child safety chain tensioner
  • Timber fit screws

Inside (recess) mount installation

 Step 1: Mount the brackets

  • Hold the brackets into place in the recess of the window frame
  • Clearly mark where you are going to position your brackets and screws, and pre drill screw holes if necessary
  • Fix the brackets into place by screwing two screws per bracket into the pilot holes

 Step 2: Install the blind

  • Put the chain control side into the bracket. Make sure the chain hangs down evenly out of the front and the back of the chain control
  • Hold the blind onto the bracket and then push the spring-loaded idle (pin) end into the hole of the other bracket until the spring clicks into place

 Step 3: Install the child safety tensioner

  • Install the chain safe tensioner by sliding it over the chain and screwing through the bottom hole of the tensioner into the frame. For more information on child safety, please refer to our child safety page

Outside (face) mount installation

 Step 1: Mount the brackets

  • Hold the brackets level with the top edge of the frame (or if you are mounting onto a wall, where you would like your blind to sit on the wall)
  • Clearly mark where you are going to position your brackets and screws and pre drill screw holes if necessary
  • Fix the brackets into place using two screws per bracket

 Step 2: Install the blind

  • Put the chain control side into the bracket. Make sure the chain hangs down evenly out of the front and the back of the chain control
  • Hold the blind onto the bracket and then push the spring-loaded idle (pin) end into the hole of the other bracket until the spring clicks into place

 Step 3: Install the child safety tensioner

  • Install the chain safe tensioner by sliding it over the chain and screwing through the bottom hole of the tensioner into the frame. For more information on child safety, please refer to our child safety page

Removing the blind

  • Unscrew the child safety chain tensioner
  • Turn the clear, corrugated wheel at the idle pin end anticlockwise, until the pin retracts, this will allow the blind to drop down from the bracket
  • You can then remove the chain drive end from it’s bracket

CONNECT WITH US